Electrochemical Preparation of Ferrates in NaOH Melts

Authors

  • E. Kubiňáková Institute of Inorganic Chemistry, Technology and Materials, Faculty of Chemical and Food Technology, Slovak University of Technology, Bratislava, Slovakia
  • M. Gál Institute of Inorganic Chemistry, Technology and Materials, Faculty of Chemical and Food Technology, Slovak University of Technology, Bratislava, Slovakia
  • K. Kerekeš Institute of Inorganic Chemistry, Technology and Materials, Faculty of Chemical and Food Technology, Slovak University of Technology, Bratislava, Slovakia
  • J. Híveš Institute of Inorganic Chemistry, Technology and Materials, Faculty of Chemical and Food Technology, Slovak University of Technology, Bratislava, Slovakia

Keywords:

ferrate, electrochemical oxidation, electrolysis, green oxidant

Abstract

In recent years the interest in novel oxidation agents has increased significantly. Ferrates are used as strong, non-toxic oxidants yielding no harmful by-products, and as efficient coagulants in waste water treatment. Electrochemical ferrate preparation is carried out in molten low-water NaOH-H2O systems. We focused on the optimization of experimental parameters for the preparation of Fe(VI) on laboratory scale. An impact of anode material, current density, temperature and electrolysis time on the process efficiency was examined. On the whole the best results are obtained using a high-purity Fe anode, a maximum acceptable current density and the lowest possible temperature.

Downloads

Published

2015-09-15

How to Cite

Kubiňáková, E., Gál, M., Kerekeš, K., & Híveš, J. (2015). Electrochemical Preparation of Ferrates in NaOH Melts. Chemické Listy, 109(9), 714–717. Retrieved from http://www-.chemicke-listy.cz/ojs3/index.php/chemicke-listy/article/view/317

Issue

Vol. 109 No. 9 (2015)

Section

Articles